Sys Command Examples; Sys Version - ZyXEL Communications P-861H-G2 User Manual

Prestige 861H Series User's Guide
sys Command Summary
Table 75
MODULE COMMAND
dreset
romreset
atsh
xmodemmode
socket
filter
ddns

30.4 sys Command Examples

These are some examples of the commands that belong to the sys (system) group of
commands.

30.4.1 sys version

Syntax:
This command clears the system error log.
The following screen displays the RAS code, firmware version, system uptime and bootbase
version
255
SUB-
ARGUMENTS
COMMAND
cnt [value]
[crc|checksum
]
netbios
disp
config <0:LAN
to WAN, 1:WAN
to LAN,
6:IPSec pass
through><on|o
ff>
debug
display
restart
logout
sys version
DESCRIPTION
Sets (0-34463) or displays the current
watchdog count (in 1.6 sec units).
Resets node and mask.
Restores the factory default configuration
file.
Displays the mode that Xmodem uses.
Displays the system socket's ID #, type,
control block address (PCB), IP address and
port number of peer device connected to the
socket (Remote Socket) and task control
block (Owner).
Displays the current NetBIOS filter modes.
Sets NetBIOS filters.
Turns on/off the displaying of DDNS debug
messages.
Displays DDNS information.
Restarts DDNS.
This command has no effect.
Chapter 30 System Commands