Table of Contents
Advertisement
Chapter 19 IPv6
19.1 IPv6 Commands Summary
This table describes the commands.
Table 101 IPv6 Commands Summary
COMMAND
ip inband address ipv6 <ipv6-
address>/<mask>
ip inband default-gateway
ipv6 <ipv6-address>
no ipv6 inband
ip outband address ipv6
<ipv6-address>/<mask>
no ipv6 outband
ip ipv6 default-management
<inband|outband>
show ip ipv6
show ip ipv6 default-router
show ip ipv6 destination
show ip ipv6 neighbor
show ip ipv6 prefix
show ip ipv6 route
show ip ipv6 default-
management
ping ipv6 <ipv6-address>
[size <size>] [-t]
148
DESCRIPTION
Manually configures a static in-band management IPv6 global address.
ipv6-address: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
: 0 ~ 127
mask
Manually configures a static in-band IPv6 global address for the default
outgoing gateway.
ipv6-address: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
Removes the manually configured in-band management IPv6 address
and default gateway address.
Manually configures a static out-of-band management IPv6 global
address.
ipv6-address: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
: 0 ~ 128
mask
Removes the manually configured out-of-band management IPv6
address and default gateway address.
Sets whether the IES uses the in-band or out-of-band traffic flow to
send packets originating from itself (such as SNMP traps) or with an
unknown source.
Displays the link-local addresses the IES generated automatically. This
also shows the manually configured inband/out-of-band management
IPv6 address and default gateway address.
Displays IPv6 addresses of on-link routers that will help forward
packets.
Displays the mapping list of the next-hop address to an IPv6
destination address.
Displays the neighbor cache, which lists the MAC addresses of the IES's
interfaces and neighboring devices.
Displays the list of on-link prefixes. The prefixes are used to determine
whether an IP address is on the same link as the IES or should be
reached through a router. A prefix is considered to be on-link when it is
assigned to an interface on a link. It's used to determine if an address
is on the IES's subnet and can be reached directly without passing
through a router. An on-link interface is directly connected to the IES or
connected through another switch.
Displays the IPv6 routing table.
Displays packets' default outgoing interface.
Sends Ping packets to the specified Ethernet device.
ipv6-address: 2000:: ~ 3fff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
size: 0 ~ 1472
: ping continuously until Ctrl-C is pressed
-t
M
P
C
13
C
13
C
13
C
13
C
13
C
13
E
3
E
3
E
3
E
3
E
3
E
3
E
3
E
0
IES4005M User's Guide
Advertisement
Table of Contents
Troubleshooting
