Msc1002G Ports; Alarm Connections - ZyXEL Communications IES4005M User Manual

Chapter 3 Management Cards
Table 4 Management Switch Card LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
The following LEDs apply to the SFP slots.
LNK Green
ACT Green
The following LEDs apply to the Gigabit Ethernet ports labeled 3 and 4.
Green
Amber

3.2.2 MSC1002G Ports

This table describes the ports on the MSC1002G.
Note: Install the management card before you make the hardware connections. See
Section 8.3.1 on page
Table 5 Management Card Port Descriptions
LABEL
SFP1, SFP2
3, 4
ALARM
CONSOLE2
MGMT
CONSOLE1

3.2.3 Alarm Connections

The IES ALARM connector is an RJ-45 female connector which provides 4 external alarm inputs for
normal close circuit, normal open circuit, and common dry contacts.
24
On The optical Ethernet link is up.
Off There is no optical Ethernet link.
Blinking There is optical Ethernet activity.
Off The connection is idle.
Blinking There is Ethernet traffic at 1000 Mbps.
On A 1000 Mbps Ethernet link is up.
Off The 1000 Mbps Ethernet link is down.
Blinking There is Ethernet traffic at 10/100 Mbps.
On A 10/100 Mbps Ethernet link is up.
Off The 10/100 Mbps Ethernet link is down.
61.
DESCRIPTION
These are slots for SFP (Small Form Factor Pluggable) transceivers used to either connect to
the backbone network or do subtending. See
information.
These RJ-45 Gigabit Ethernet ports are for connecting to a Gigabit Ethernet device that is part
of a high-bandwidth backbone network or doing subtending.
This RJ-45 connector is for connecting to alarm output terminals on other equipment.
This RJ-45 RS-232 port is for connecting to a UPS. When you deploy the IES4005M with a
UPS, only the POTS modules function during a power outage so subscribers can still make
emergency calls.
Note: At the time of writing, the IES only complies with a Delta GES-R1K UPS.
This is an RJ-45 Ethernet port for connecting to an Ethernet network for out-of-band
management (a separate channel for management that is not part of the channels that are
usually used for data transfer).
This mini RJ-11 port is for connecting to a computer for local management.
Section 3.2.6.1 on page 26
IES4005M User's Guide
for more