ZyXEL Communications IES4005M User Manual page 85

Table 58 Alarm Commands Summary (continued)
COMMAND
alarm notification-severity <severity>
show interface voip <slot/portlist> alarm line-
control
show interface voip <slot/portlist> alarm
notification-severity
interface voip <slot/portlist>
exit
alarm notification-severity <severity>
alarm line-control
no alarm line-control
alarm line-control interval <interval>
show interface ge <port> alarm notification-
severity
show interface ge <port> alarm line-control
interface ge-nni <portlist>
exit
alarm notification-severity <severity>
alarm line-control
no alarm line-control
IES4005M User's Guide
DESCRIPTION
Configures the minimum severity level for
sending out alarm notifications (SNMP trap
and SYSLOG) about the specified ports.
Displays the time interval settings for
reporting alarms when you enable alarm line-
control on the specified DSL ports.
Displays the minimum severity level to send
out alarm notifications (SNMP trap and
SYSLOG) on the specified DSL ports.
Enters the sub-command mode for configuring
the specified VoIP ports.
Leaves the VoIP port configuration sub-
command mode.
Configures the minimum severity level for
sending out alarm notifications (SNMP trap
and SYSLOG).
Has the IES report alarms for the ports at
regular intervals instead of immediately.
Turns off interval-based reporting of alarms so
the IES reports alarms immediately.
Sets the time interval (10-600 seconds) the
IES uses for sending alarms about these
ports. This applies when you enable alarm
line-control on these ports.
Displays the minimum severity level to send
out alarm notifications (SNMP trap and
SYSLOG) on the specified Gigabit Ethernet
uplink interfaces.
You can specify a single port <1>, all ports
<*> or a list of ports <1,2>. You can also
include a range of ports <1-2>.
Displays the time interval settings for
reporting alarms when you enable alarm line-
control on the specified Gigabit Ethernet
uplink interfaces.
You can specify a single port <1>, all ports
<*> or a list of ports <1,2>. You can also
include a range of ports <1-2>.
Configures the specified Gigabit Ethernet
uplink ports. You can specify a single port
<1>, all ports <*> or a list of ports <1,2>.
You can also include a range of ports <1-2>.
Leaves the Gigabit Ethernet uplink port
configuration.
Configures the minimum severity level for
sending out alarm notifications (SNMP trap
and SYSLOG).
Has the IES report alarms for the ports at
regular intervals instead of immediately.
Turns off interval-based reporting of alarms so
the IES reports alarms immediately.
Chapter 11 Management
M P
C 13
E 1
E 1
C 13
C 13
C 13
C 13
C 13
C 13
E 1
E 1
C 13
C 13
C 13
C 13
C 13
85