ZyXEL Communications IES4005M User Manual page 111

Table 75 ACL Commands Summary (continued)
COMMAND
dest-l4-port range <start-
port> <end-port>
source-l4-port <port>
dest-l4-port <port>
no change-qos
no ether-type
no source-mac
no dest-mac
no source-oui
no dest-oui
no inner-vlan
no outer-vlan
no inner-pbit
no outer-pbit
no source-ip
no dest-ip
no protocol
no ip-precedence
no dscp
no source-ipv6
no dest-ipv6
no next-header
no traffic-class
no source-l4-port
no dest-l4-port
Use the following sub-commands to set the actions for the ACL profile.
change-qos <queue-id>
drop
no drop
rate-limit <rate-limit>
no rate-limit
change-inner-pbit <pbit>
IES4005M User's Guide
DESCRIPTION
Specifies a layer 4 destination port range.
Specifies a layer 4 source port.
port: 0-65535
Specifies an layer 4 destination port.
Disables changing the QoS level of matched packets.
Removes the Ethernet type from the profile.
Removes the source MAC from the profile.
Removes the destination MAC from the profile.
Removes the source MAC OUI from the profile.
Removes the destination MAC OUI from the profile.
Removes the inner VLAN ID from the profile.
Removes the outer VLAN ID from the profile.
Removes the inner VLAN priority bit from the profile.
Removes the outer VLAN priority bit from the profile.
Removes the source IP address or IP address range from the
profile.
Removes the destination IP address or IP address range from the
profile.
Removes the IP protocol from the profile.
Removes the IP precedence from the profile.
Removes the IP DSCP from the profile.
Removes the source IPv6 address from the profile.
Removes the destination IPv6 address from the profile.
Removes the IPv6 next header from the profile.
Removes the IPv6 traffic class from the profile.
Removes the source L4 port or L4 port range from the profile.
Removes the destination L4 port or L4 port range from the profile.
Change the QoS level of matched packets.
queue-id: 0-7
7:highest priority
0:lowest priority
Discards packets that match the profile.
Disables dropping of matching packets.
Limits the receiving rate for packets that match the profile.
rate-limit: 32-100000 in kbps
Disables rate limiting for matching packets.
Changes the inner VLAN inner priority bit of matching packets to
the specified one.
Chapter 13 Switch Features
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
111