ZyXEL Communications IES4005M User Manual page 86

Chapter 11 Management
Table 58 Alarm Commands Summary (continued)
COMMAND
alarm line-control interval <interval>
show interface system alarm
interface system
exit
alarm notification-severity <severity>
alarm alarm-input <index> description
<description>
no alarm alarm-input <index>
show alarm alarm-input
alarm dua
no alarm dua
show alarm dua
alarm sys-suppress
no alarm sys-suppress
show alarm sys-suppress
alarm coa issue-threshold <issue-threshold>
alarm coa clear-threshold <clear-threshold>
alarm coa sample-seconds <seconds>
86
DESCRIPTION
Sets the time interval (10-600 seconds) the
IES uses for sending alarms about these
ports. This applies when you enable alarm
line-control on these ports.
Displays the system-wide alarm settings.
Enters the sub-command mode for configuring
system-wide settings.
Leaves the system-wide settings sub-
command mode.
Configures the minimum severity level for
sending out alarm notifications (SNMP trap
and SYSLOG).
Configures the alarm input description.
: 1-7
index
: up to 31 printable characters
description
Loads the default alarm input description.
Displays the alarm input descriptions.
Enables polling of a connected UPS and issues
delta UPS alarms if necessary.
Disables polling of a UPS, and clears all issued
delta UPS alarms.
Displays whether delta UPS alarm is enabled,
UPS model name, and UPS firmware version.
Enables alarm system suppression. This
suppresses all traps except those with the
"event" severity level. The IES still records all
alarms and syslog (if enabled).
Disables alarm system suppression.
Displays the alarm system suppression
setting.
Configures the threshold for issuing an CPU
overload alarm.
issue-threshold: percent of CPU usage. 0 ~
100.
Set the CPU overload alarm issue threshold
higher than the CPU overload alarm clear
threshold.
Configures the threshold for clearing an CPU
overload alarm.
clear-threshold: percent of CPU usage. 0 ~
100.
Set the CPU overload alarm clear threshold
lower than CPU overload alarm issue
threshold.
Configures the number of sample seconds
used for monitoring for a CPU overload.
seconds: 1 ~ 60
M P
C 13
E 1
C 13
C 13
C 13
C 13
C 13
E 1
C 13
C 13
E 1
C 13
C 13
E 1
C 13
C 13
C 13
IES4005M User's Guide