Command Examples; Remote Management; Remote Management Commands Summary - ZyXEL Communications IES4005M User Manual

2u 5-slot temperature-hardened chassis msan
Table of Contents

Advertisement

Table 71 performance management commands summary (continued)
Command
alarm-profile <alarm-profile>
clear interface voip <slot/
portlist> performance
show interface voip <slot/
portlist> performance
<current|15-min|1-day>

11.9.2 Command Examples

This example first shows how to configure a performance management alarm profile named
Alarm1. Then allow 1234 packets to receive in a 15-minute period. Finally, apply the alarm profile
Alarm1 to GE port 1.
ras# config
ras(config)# ge-nni alarm-profile Alarm1
ras(config-Gsx-alm-profile-Alarm1)# 15min-rxPkts-threshold 1234
ras(config-Gsx-alm-profile-Alarm1)#exit
ras# config
ras# (config)# interface-ge-nni-1
ras(config-interface-ge-nni-1)# alarm-profile Alarm1

11.10 Remote Management

Use these commands to specify remote hosts that can access the IES for management.

11.10.1 Remote Management Commands Summary

The following table describes commonly used parameter notation for these commands.
Table 72 remote management command parameters
Notation
index
ip-address
ipv6-address
This table describes the commands.
Table 73 remote management command summary
Command
show remote-management
remote-management <index>
exit
active
IES4005M User's Guide
Description
Configures the referenced VoIP alarm profile to specified UNI ports.
Clears VoIP performance statistics for the specified ports.
Displays VoIP performance statistics for the specified ports currently, in
the most recent 15-minute, or in the past one day time segment.
Description
The index number of a trusted host entry, 1~16. You can specify a single entry <1>,
all entries <*> or a list of entries <1,3>. You can also include a range of entries <1-
5>.
An IPv4 IP address, 0.0.0.0 ~ 223.255.255.255
An IPv6 IP address, :: ~ ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff
Description
Displays all IPv4 trusted host information.
Enters the sub-command mode for configuring the specified IPv4
trusted host entry.
Leaves the IPv4 trusted host configuration sub-command mode.
Enables the IPv4 trusted host entry.
Chapter 11 Management
M
P
C
13
E
13
E
13
M
P
E
13
C
13
C
13
C
13
105

Advertisement

Table of Contents
loading

Table of Contents