Table of Contents
Advertisement
11.9 Performance Management
Use these commands for performance management.
11.9.1 Performance Management Commands Summary
The following table describes commonly used parameter notation for these commands.
Table 70 performance management command parameters
Notation
alarm-profile
portlist
threshold
This table describes the commands.
Table 71 performance management commands summary
Command
no ge-nni alarm-profile <alarm-
profile>
show ge-nni alarm-profile [alarm-
profile]
ge-nni alarm-profile <alarm-
profile>
exit
15min-txoctets-threshold
<threshold>
15min-txpkts-threshold
<threshold>
15min-txbcastpkts-threshold
<threshold>
15min-txmcastpkts-threshold
<threshold>
15min-rxoctets-threshold
<threshold>
15min-rxpkts-threshold
<threshold>
15min-rxbcastpkts-threshold
<threshold>
15min-rxmcastpkts-threshold
<threshold>
15min-rxcrc-threshold
<threshold>
15min-rxunder-threshold
<threshold>
15min-rxover-threshold
<threshold>
15min-rxfrag-threshold
<threshold>
IES4005M User's Guide
Description
The name of an alarm profile. Use up to 31 printable characters.
The number of uplink port(s), 1-2. You can use 1,2, 1~2 or * to specify all the ports.
0 ~ 18446744073709551615. An alarm is triggered if this number is exceeded.
Description
Deletes the specified Gigabit Ethernet (GE) port alarm profile.
Displays all or the specified GE port alarm profile.
Enters the sub-command mode for configuring a GE port alarm profile.
Leaves the GE port alarm profile configuration sub-command mode.
Configures the number of octets of Ethernet frames allowed to transmit
in any 15-minute period.
Configures the number of packets allowed to transmit in any 15-minute
period.
Configures the number of broadcast packets allowed to transmit in any
15-minute period.
Configures the number of multicast packets allowed to transmit in any
15-minute period.
Configures the number of octets of Ethernet frames allowed to receive
in any 15-minute period.
Configures the number of packets allowed to receive in any 15-minute
period.
Configures the number of broadcast packets allowed to receive in any
15-minute period.
Configures the number of multicast packets allowed to receive in any
15-minute period.
Configures the number of CRC (Cyclical Redundancy Check) alignment
errors allowed to occur in any 15-minute period.
Configures the number of packets that were too small allowed to
receive in any 15-minute period.
Configures the number of packets that were too big allowed to receive
in any 15-minute period.
Configures the number of fragmented frames allowed to receive in any
15-minute period.
Chapter 11 Management
M
P
C
13
E
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
103
Advertisement
Table of Contents
Troubleshooting
