Chapter 23 Static Route - ZyXEL Communications IES4005M User Manual

Use these commands to configure static routes to tell the IES how to forward IP traffic.
The IES uses IP for communication with management computers, for example using Telnet, SSH, or
SNMP. Use IP static routes to have the IES respond to remote management stations that are not
reachable through the default gateway. The IES can also use static routes to send data to a server
or device that is not reachable through the default gateway, for example when sending SNMP traps
or using ping to test IP connectivity.
The following section lists the commands for this feature.
Table 111 Static Route Commands Summary
COMMAND
show ip route
show ip route static
ip route <ip-address>/<mask>
<next-hop-ip>
no ip route <ip-address>/<mask>
IES4005M User's Guide
C
HAPTER
DESCRIPTION
Displays the IP routing table.
Displays the static routes.
Creates a static route. If the
exists, the IES deletes the existing route first.
next-hop-ip: IP address of the next device. 0.0.0.0-
223.255.255.255
Removes a specified static route.
Static Route
already
< > < >
ip-address mask
2 3
M P
E 13
E 13
C 13
C 13
163