Removing Msc And Line Cards - ZyXEL Communications IES4005M User Manual

8.3.2 Removing MSC and Line Cards

Use the following procedure to remove the management switch card and line cards from the main
chassis.
Disconnect all cables from the card.
1
Loosen the two thumbscrews.
2
Pull the two ejector levers firmly until the front of the card is clear of the main chassis. Pull the
3
ejector levers until they are perpendicular to the front panel.
Note: The MSC has more connector pins than the other cards so when removing it you
need to exert more force to get the front of the MSC clear of the main chassis.
Grasp the center of the front panel of the card with one hand and place the other hand under the
4
card to support it.
Slide the card out of the slot.
5
IES4005M User's Guide
Chapter 8 Hardware Installation
63