Ip Media Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
Emergency Message Condition
configure voip > sbc settings >
sbc-emerg-condition
[SBCEmergencyCondition]
Emergency RTP DiffServ
configure voip > sbc settings >
sbc-emerg-rtp-diffserv
[SBCEmergencyRTPDiffServ]
Emergency Signaling DiffServ
configure voip > sbc settings >
sbc-emerg-sig-diffserv
[SBCEmergencySignalingDiffServ]

72.13 IP Media Parameters

The IP media parameters are described in the table below.
Parameter
IPMedia Detectors
configure voip > media ipmedia >
ipm-detectors-enable
[EnableDSPIPMDetectors]
Number of Media Channels
configure voip > sbc settings >
media-channels
[MediaChannels]
Conferencing Parameters
Conference ID
Version 7.2
Defines the index of the Message Condition rule in the Message
Conditions table that is used to identify emergency calls.
Note: The device applies the rule only after call classification
(but before inbound manipulation).
Defines DiffServ bits sent in the RTP for SBC emergency calls.
The valid value is 0 to 63. The default is 46.
Defines DiffServ bits sent in SIP signaling messages for SBC
emergency calls. This is included in the SIP Resource-Priority
header.
The valid value is 0 to 63. The default is 40.
Table 72-75: IP Media Parameters
Enables the device's DSP detectors for detection features such
as AMD.

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is required.

The DSP Detectors feature is available only if the device is
installed with a License Key that includes this feature. For
installing a License Key, see 'License Key' on page 857.

When enabled (1), the number of available channels is
reduced.
Defines the maximum number of DSP channels allocated for
various functionalities such as transcoding, IP conferencing.
The default is 0.
Note:

For the parameter to take effect, a device reset is required.


The SBC application does not require DSP channels. The
SBC application uses DSP channels only if media
transcoding is needed, where two DSP channels are used
per transcoding session.

Other DSP channels can be used for PSTN interfaces.
Defines the Conference Identification string.
1315
72. Configuration Parameters Reference
Description
Description
Mediant 800B Gateway & E-SBC