AXIOMTEK SBC81870 Series User Manual page 105

Floppy Disk Cntrlr Error Or No Cntrlr Present:
Cannot find or initialize the floppy drive controller. Make sure
the controller is installed correctly and firmly. If there are no
floppy drives installed, be sure the Diskette Drive selection in
Setup is set to NONE.
Invalid Eisa Configuration
Please Run Eisa Configuration Utility
The non-volatile memory containing EISA configuration
information was programmed incorrectly or has become corrupt.
Re-run EISA configuration utility to correctly program the
memory.
Note: When this error appears, the system will boot in ISA
mode, which allows you to run the EISA Configuration Utility.
Keyboard Error Or No Keyboard Present
Cannot initialize the keyboard. Make sure that the keyboard is
properly attached and no keys being pressed during the boot.
If you are purposely configuring the system without a keyboard,
set the error halt condition in Setup to HALT ON ALL, BUT
KEYBOARD. This will cause the BIOS to ignore the missing
keyboard and continue the boot.
Memory Address Error At ... :
Indicates a memory address error at a specific location. You
can use this location along with the memory map for your
system to find and replace the bad memory chips.
Memory Parity Error At ... :
Indicates a memory parity error at a specific location. You can
use this location along with the memory map for your system to
find and replace the bad memory chips.
Memory Size Has Changed Since Last Boot:
Memory has been added or removed since the last boot. In
EISA mode use Configuration Utility to reconfigure the memory
configuration. In ISA mode enter Setup and enter the new
memory size in the memory fields.
Trouble Shooting
® ®
SBC81870 Intel Pentium
:
:
M w/ DDR/VGA/Dual LAN
99