Table of Contents
Advertisement
Chapter 6 Wideband Data Specific Operation
Provisioning
This section provides information for provisioning the RF Gateway 1 for Cisco
Wideband operation.
Prerequisite Configurations:
GbE input ports, including Video/Data IP address
QAM outputs
Channel Application Mode
Channel Application Mode
To Verify Channel Application Mode
1
Navigate to the Maps page.
2
In the tree menu, select Map Configuration.
Result: Channel Application Mode is revealed for each output carrier.
Note: The correct setting is "Data".
Data Map Configuration
For a specific output carrier, using the Maps/Data Map web page, the operator can
configure:
Input Stream Type
Allowable ingress port or port-pair
Input stream Destination UDP port
106
78-4025112-01 Rev H0
Advertisement
Table of Contents
Need help?
Do you have a question about the RF Gateway 1 and is the answer not in the manual?