Table of Contents
Advertisement
Chapter 3 General Configuration and Monitoring
Parameter
Spectrum Inversion
PRBS Stuffing
Application Mode
Interleave Depth
PMT Rate
PAT Rate
DTI Offset
Notes:
1
You can change values for one row and then update them all by clicking Update
All Rows.
2
Application mode SDV corresponds to GQI mode of operation.
3
A chassis can be configured either to operate in GQI VOD system or GQI
Broadcast.
4
In GQI PowerKey Broadcast mode of operation, only 4 channels per port are
supported.
Additional Configuration
The RFGW-1 provides several additional configuration parameters that apply as
needed.
The following parameters are added in System Release 5.1.x.
Parameter
Automatic Configuration
Save
Pre Encrypted Type
MPTS Defaults
32
Description
The spectrum can be configured as normal or swap.
"On" setting is recommended.
Allows the user to configure various network scenarios, including
video, data, SDV, and NGOD.
Allows you to pick the interleaving depth.
Default setting recommended.
Default setting recommended.
Timing offsets when channel is set to data mode.
Description
When enabled, configuration changes applied to the RFGW-1 are
automatically saved to the database.
When pre-encrypted streams are routed, the correct CA system
must be selected to ensure SI tables are routed correctly.
When creating sessions from MPTS sources (in the Stream Map),
the default behavior can be set to regenerate the output PAT, or
pass the entire MPTS intact.
78-4025112-01 Rev H0
Advertisement
Table of Contents
