Chapter 4 Table-Based Video Specific Operation
Provisioning
The following sections provide information for provisioning the RF Gateway 1 for
table-based video operation.
Prerequisite Configurations:
GbE input ports, including Video/Data IP address
QAM outputs
Channel Application Mode = Video
Once a carrier is in video mode, the video stream map becomes active for that
carrier. The video stream map serves as a routing table, which maps incoming video
to unique output carriers.
Channel Application Mode
To Verify Channel Application Mode
1
Navigate to the Maps page.
2
In the tree menu, select Map Configuration.
Result: Channel Application Mode is revealed for each output carrier.
Note: The correct setting is "Data".
Video Stream Map Configuration
For a specific output carrier, using the Maps/Video Stream Map page, the following
can be configured:
Input Stream Destination IP address and UDP port
Allowable ingress port or port-pair
84
78-4025112-01 Rev H0