Table of Contents
Advertisement
Chapter 3 General Configuration and Monitoring
Configuring, Monitoring, and Fault Management
via SNMP
The RFGW-1 supports a set of proprietary and standard MIBs via SNMPv2. Through
SNMP, the RFGW-1 can be configured and monitored. In addition, Fault
Management is supported through the generation of SNMP traps for all system
alarms and events.
The following table shows the MIBs supported.
MIB Name
CISCO-RFGW-1-MIB (proprietary)
CISCO-RFGW-1-TRAP-MIB.mib
(proprietary)
DOCS-IF-MIB
ENTITY-MIB
SNMPv2-MIB
IF-MIB
80
Description
This MIB module contains objects necessary for
management of the RFGW-1 device. This includes status,
statistics, equipment inventory, remote
download/upload, table definition, and other
configurations as needed for the QAM.
Trap control MIB for the RFGW-1.
This is the MIB Module for DOCSIS 2.0 compliant Radio
Frequency (RF) interfaces in Cable Modems (CM) and
Cable Modem Termination Systems (CMTS).
The MIB module for representing multiple logical
entities supported by a single SNMP agent.
The MIB module for SNMP entities.
The MIB module to describe generic objects for network
interface sub-layers. This MIB is an updated version of
MIB-II's ifTable, and incorporates the extensions defined
in RFC 1229.
78-4025112-01 Rev H0
Advertisement
Table of Contents
