Steps To Take; Configuring Broadcast Scrambling And Dual Encryption Broadcast - Cisco RF Gateway 1 Configuration Manual

Chapter 13 Encryption and Scrambling

Steps To Take

Before scrambling can be used, the following steps must be completed.
1 Prerequisite Configurations
a Configure the GbE input ports, including Video/Data IP address. For
information regarding GbE Interface Configuration, see the Cisco RF Gateway
1 Configuration Guide, part number 78-4025112-01.
b Configure the QAM outputs. For information regarding Enabling QAM
Ports, see the Cisco RF Gateway 1 Configuration Guide, part number 78-
4025112-01.
Note: ONID and TSID must match EIS settings for CVC simulcrypt.
c Configure Channel Application Mode (SDV for CVC simulcrypt operation,
Video for VOD map mode). For information regarding Channel Application
Mode, see the Cisco RF Gateway 1 Configuration Guide, part number 78-
4025112-01.
2 Simulcrypt Controller Configurations
a Configure Scrambling General Parameters. Refer to Configuring Scrambling
General Settings (on page 182).
Note: For CVC simulcrypt, Core Encryption should be set to DVB CSA.
b Configure Scrambling Specific Parameters. Refer to Configuring Scrambling
Specific Parameters (on page 183).
c Assign one or multiple ECMG(s) to the RFGW-1 and configure the ECMG-
specific parameters. Refer to Entitlement Control Message Generators (on
page 183).
Note: CVC Simulcrypt should use "ECM ID" instead of "Auto" to satisfy
reference AC requirements.
d Assign one or multiple EIS(s) to the RFGW-1 and configure the EIS-specific
parameters. Refer to Event Information Schedulers (on page 198).

Configuring Broadcast Scrambling and Dual Encryption Broadcast

Follow instructions below to select scrambler parameters.
1 Navigate to the System Configuration page.
180 78-4025112-01 Rev H0