Table of Contents
Advertisement
Result: SRM Configuration page is shown.
2
Enter a valid SRM IP Address.
3
Set the 'GQI Announce Mode' to Enabled, if the RFGW-1 must send the GQI
Announce Messages to the SRM to indicate the events on the Video Plane.
Legacy Mode
Legacy mode is intended to make older DNCS software versions (greater than 4.5) to
support the RFGW-1 by spoofing the DNCS into thinking the RFGW-1 is a GQAM.
A DNCS crash is likely if the Legacy Mode is selected with new DNCS software
versions earlier than 4.5.
DO NOT SELECT LEGACY MODE IF THE DNCS IS RUNNING A SOFTWARE
VERSION earlier than 4.5.
QAM Channel Configuration
To Provide Transport Stream ID and Verify Channel Application Mode
1
Navigate to the QAMS/QAM Configuration page.
2
Select the QAM Card/RF Port/Channel page.
78-4025112-01 Rev H0
Provisioning
101
Advertisement
Table of Contents
