Table of Contents
Advertisement
Chapter 14 Secuirty Features
Result: The following window is displayed.
7
Click OK.
8
Click Login on the main menu bar.
The following screen is displayed.
9
Enter User Name and Password provisioned on the RADIUS server.
Remote User Management
When logged in as "rfgw1" or any RADIUS user (in Remote mode), the user can
access all configurable RF Gateway 1 web pages.
In the Radius users configuration file in RADIUS server, set the cisco-avpair as
cisco-avpair = "shell:priv-lvl=15" in order to allow read-write access of the
RFGW1 web pages for that Radius user.
Operators can configure the default user ID ("rfgw1") as a Local and/or RADIUS
user. The RF Gateway 1 uses one or the other for its authentication credentials.
Operators use their RADIUS server interface to setup and change RADIUS based
users and passwords.
Local password capability is also enabled in Remote (multi-user) mode. Hence,
the Local user and its password are still valid. For this reason, it is essential to
change the factory default password as soon as possible. Also, while in Remote
mode, System/Authentication/Change Password feature can be used to change
a Local user password only. The RF Gateway 1 operator must use the RADIUS
server interface to make changes to its remote user credentials. This cannot be
performed using the RF Gateway 1 management interface.
If remote authentication does not succeed using the user credentials entered,
208
78-4025112-01 Rev H0
Advertisement
Table of Contents
