Cisco RF Gateway 1 Configuration Manual page 43

To Configure Individual Carrier Output Parameters
1 Navigate to the QAMS page.
2 Expand the tree menu, and select the desired QAM Channel.
Result: The QAM Channel Configuration window is displayed.
3 In the Transport Stream ID field, enter stream ID.
4 In the Channel Spectrum Inversion field, set the parameter to Normal (for most
applications).
Note: The following table compares the RF Gateway 1 to an xDQA-24 with
respect to Channel Spectrum Inversion and its interpretation.
ITU Annex
Setting
ITU-A
ITU-A
ITU-B
ITU-B
ITU-C
ITU-C
5 In the Channel PRBS Stuffing field, set the parameter to On (for most
applications.)
6 In the Channel Interleave Depth field, select the interleave type.
7 In the Channel PMT Rate and Channel PAT Rate fields, enter desired playout rates.
8 Click Apply.
9 Click Save.
78-4025112-01 Rev H0
xDQA-24 ITU RF Gateway 1 ITU
Setting Setting
Normal Inverted
Inverted Normal
Normal Normal
Inverted Inverted
Normal Inverted
Inverted Normal
Configuring QAM Output
19