System Events - Cisco RF Gateway 1 Configuration Manual

System Events

System Events are conditions without state that the user may want to be aware of.
The RF Gateway 1 provides user notification of these events. These notifications can
be via SNMP traps or the system log. System events cannot be masked or filtered
and will always be indicated on the system.
The default events supported by the system are defined in the event configuration
area of the database. The default event configuration parameters include items such
as event label, mask, and enabled notifications. These parameters are defaults and
are not configurable through the web interface.
The system reports additional information on actual events such as event originator,
instance, and other descriptive details including triggering threshold, actual value,
and units. Supported events are described in the following table.
Name
QAM Card Mount
QAM Configuration
Change
Power Supply
Mount
SFP Mount
Download
Log Near full
Log Almost full
Log Full
Configuration
Backup
Configuration
Restore
Configuration Save
Release Invalid
Startup
DOCSIS
DTI
Exception
Download License
OLS
EIS Active Proxy
Removed
78-4025112-01 Rev H0
Description
A QAM card has been inserted or removed from the chassis.
A configuration change has been detected on a QAM card parameter.
A redundant power supply has been inserted or removed from the
chassis.
An SFP has been inserted or removed from the RF Gateway chassis.
A download event has occurred on the chassis.
The log is 80% full.
The log is 90% full.
The log is 100% full and will roll over.
The system configuration has been backed up.
The system configuration has been restored.
The system configuration has been saved to the flash file system.
Invalid inactive release detected on the system.
The RFGW has entered startup (boot)
DTI sync changed from/to active. DOCSIS SYNC messages are
received/not received from CMTS.
Operating mode of the DTI port change.
Exception reported by low level operating system.
The RFGW-1 has been instructed to download a license via FTP. FTP
complete.
License feature has been added.
Active EIS proxy has been removed.
Fault Management of the RF Gateway 1
67