Mitsubishi Electric GOT2000 Series Connection Manual page 318


Setting of [Bar Code] of GT Designer3
Item
Read Data Direct Input to Object
Device
Device Points
*1
Header
*1
Terminator
Writing Byte Order
Fills a blank when Imported data is
not filled in Writing Points
Filling Data
*1 Keep consistency with the bar code reader setting.
POINT POINT POINT
[Bar Code] of GT Designer3
For the [Bar Code] setting in GT Designer3, refer to the
following manual.
GT Designer3 (GOT2000) Help
11 - 8
11. BAR CODE READER CONNECTION
11.5 System Configuration Examples
Set value
No
D0
6
None
CR
Low High
Check (Filling Data is available)
Space (020)

Confirmation on PLC side
Connect GX Works2 to the QCPU (Q-mode) and check
if the data, which has been read with the bar code
reader, are written in D0 to D5.
For the GX Works2 operation method, refer to the
following manual.
GX Works2 Operating Manual
(1) Confirming the device values of D0 to D5 (when
using GX Works2
Startup procedure
GX Works2 [Online]
Memory Batch Monitor]
ASCII codes are hexadecimals.
Specify [HEX] for [Value] of the GX
Works2 and confirm the read data.
[Monitor] [Device/Buffer