Mitsubishi Electric GOT2000 Series Connection Manual page 373

Communication
RFID controller
Type
*1 RS-422/485
*1 For applicable RFID controller of the type/number, configuration equipment, and for connection cables, refer to the following
Technical News.
*2 When a GT10-C02H-6PT9P unit of the sub version A or B is used, do not ground the case of the D-sub (9-pin) connector.
POINT POINT POINT
When using the RS-232 communication unit
Use the RS-232 communication unit of the GOT for connecting to an RFID controller.
However, when the RS-232 communication unit is used, the following operations cannot be supported.
(a) Using the external authentication
(b) Supplying the power to an RFID controller from the GOT
HINT HINT HINT
System configuration between the GOT and PLC
For the system configuration between the GOT and PLC, refer to each chapter.
Mitsubishi Products
Non-Mitsubishi Products 1, Non-Mitsubishi Products 2
Microcomputer, MODBUS Products, Peripherals
Connection cable
Option device
- (Built into
GOT)
GT15-RS4-9S
*1
GT15-RS4-TE
- (Built into
GOT)
List of valid devices applicable for GOT2000 series (GOT-A-0064)
GOT
PLC
Model
For the system configuration
between the GOT and PLC,
refer to each chapter.
18. RFID CONNECTION
18.2 System Configuration
Number of connectable
equipment
18
*1
18 - 3