System Timers - Samsung OfficeServ 7000 Series Programming Manual

[501] SYSTEM TIMERS

Allows the technician to adjust individual timers as necessary.
TIMER TABLE
Timer Name
AA INT DGT TIME
AA NO ACT TIME
AA TRANS TIME
ALARM TIME
ALERT TONE TIME
ALM REM.INTERVAL
ALM REM RING OFF
ATT. RECALL TIME
AUTO REDIAL INT.
AUTO REDIAL RLS.
BOOTH TIME OUT
(Hotel application only)
CALLBACK NO ANS
© SAMSUNG Electronics Co., Ltd.
OfficeServ 7000 Series Call Server Programming Manual
Default Range Unit
05 1~25 SEC
10 1~25 SEC
02 0~25 SEC
100 0-2500 MIN
1000 100-2500
MSEC
25 1-250 SEC
10 1-25 SEC
30 0-250 SEC
30 1-250 SEC
45 1-250 SEC
005 0-250 MIN
30 1-250 SEC
Description
Inter-digit time
(This option may not be available in certain
OfficeServ models.)
Time for AA to transfer the incoming call to
operator in case of no digit input within the
specified time limit.
(This option may not be available in certain
OfficeServ models.)
This is latency time before AA tranfer inbound
call to another recipient.
(This option may not be available in certain
OfficeServ models.)
This is the time the system alarm key will start
ringing after the alarm key has been silenced.
This timer sets the duration of the attention
tone preceding a call to a phone in the Voice
Announce or Auto Answer mode. This tone
will also precede a forced Auto Answer call.
This timer controls the time between ring
attempts at a station when alarm reminder is
set.
This timer controls the length of the ring cycle
duration when an alarm reminder is set at a
station.
This controls how long a transfer recall will
ring at a station before recalling the operator.
This timer controls the time between attempts
after RETRY dialing is set on a station.
This timer controls the duration of a Ring No
Answer condition on a retry number dialed
before the auto redial is automatically
cancelled.
Controls the time for which a booth phone is
enabled.
This timer controls the time before the
callback is automatically cancelled when a
callback detects Ring No Answer.
2-167