Did Number And Name Translation - Samsung OfficeServ 7000 Series Programming Manual

CHAPTER 2. MMC Programming

[714] DID NUMBER AND NAME TRANSLATION

Assigns an incoming DID call to a specific ring plan destination. It also provides a call
waiting option, if needed, so that a second incoming DID call can be received. The table is
also used to define which MOH source a caller to that DID number will hear when placed
on hold. A name up to 11 characters can be added to the number. There is a maximum of
999 entries. If there is no matching number on DID service, the call is routed to the
operator group.
Option
DGT
MOH SOURCE
PRI
RING PLAN
1: XXX, 2: XXX,
3: XXX, 4: XXX,
5: XXX, 6: XXX
CW
MC
DC
NAME
TONE
CADENCE
2-242
Digits to be received from Trunk line. (up to 16 digits may be entered)
Allows the technician to select what the calling party will hear if the call is
placed on hold. There are four possible music selections.
DID priority option. There are nine priority levels: priority 1 is the highest
and priority 9 is the lowest. When calls come into a station group and all
group members are busy, the system will assign a priority to the DDI
numbers so that calls from a high-priority DDI number will be placed at the
front of the group queue. If this option is set to NO, the call held longest in
the group queue has the highest priority.
Ring plan and destination during each ring plan. The destination can be a
station, station group, trunk or trunk group. If a trunk or trunk group is
selected the trunks must be programmed as E&M trunks to allow the
received digits to be re-sent. This is referred to as DID Repeat digits over
tie line. Entering the character 'B' means to repeat the received digits.
Call Waiting Yes/No. (Allows a second DID call to be received.)
The maximum call count. When this is set to 99, the feature will not work.
When set to 0, if a call comes in that matches DID digits and DGT field
then the system will reject the call. When set between 1 and 98, if a call
comes in that matches DID digits and DGT field then the system counts
the same DID digits, and if the count is the same or higher than this value,
the system sends busy signal to caller.
The number of digits to delete. This is useful with Tandem switching,
mixed numbering plans and DID Repeat digits over tie line.
Maximum number of digits that can be deleted is 16.
Enter up to 11 characters to identify call. Refer to MMC 104, STATION
NAME, for how to enter the name.
Assigns ring tone to DLI port.
Assigns ring cadence to SLT port.
Description
© SAMSUNG Electronics Co., Ltd.