Table 83: Settings (continued)
Parameter
PMDisconnect
PMDO_L
PMDO_F
CS7000 System Administrator Guide for Release 9.4
Example Value
If PIN Master Disconnect is set to zero, the Demand PIN Master
routes the call to reception if...
The number of retries is exhausted
●
The conference is locked
●
The conference is full
●
If PIN Master Disconnect is set to non zero, the Demand PIN
Master can disconnect the call if...
The number of retries is exhausted
●
The conference is locked
●
The conference is full
●
If PIN Master Disconnect is set to non zero, three additional
parameters modify the behaviour of PIN Master Disconnect:
PMDO_L
PMDO_F
PMDO_P
If PIN Master Disconnect is set to non zero, these three
parameters override the setting in PIN Master Disconnect. If PIN
Master Disconnect is set to zero, the PIN Master Disconnect
setting is used and the three additional parameters are ignored.
PMDO_L is ignored if PIN Master Disconnect (PMDisconnect) is
set to zero. If PIN Master Disconnect is set to non zero, PMDO_L
is used.
If PMDO_L=0, all calls to locked conferences are disconnected.
If PMDO_L=1, moderator calls to locked conferences are routed
to reception, but all other calls to locked conferences are
disconnected.
If PMDO_L=2, all calls to locked conferences are routed to
reception. Disable PMDisconnect for this condition. It defaults to
0.
PMDO_F is ignored if PIN Master Disconnect (PMDisconnect) is
set to zero. If PIN Master Disconnect is set to non zero, PMDO_F
is used.
If PMDO_F=0, all calls to full conferences are disconnected.
If PMDO_F=1, moderator calls to full conferences are routed to
reception, but all other calls to full conferences are disconnected.
If PMDO_F=2, all calls to full conferences are routed to
reception. Disable PMDisconnect for this condition. It defaults to
0.
Demand.ini
2 of 5
257
January 2006