Table of Contents
Advertisement
Table 17: Login Parameters and Custom Settings (continued)
Parameter
AutoRefresh
ZeroStartPIN
CheckPINSize
CS7000 System Administrator Guide for Release 9.4
Description
The system automatically refreshes CRS on-screen
data if you enable the AutoRefresh parameter. The
AutoRefresh parameter applies to dialogs such as
the Schedule and Recording dialogs. You can disable
AutoRefresh to reduce network traffic.
AutoRefresh=0*
Automatic refresh is disabled.
AutoRefresh=1
Automatic refresh is enabled.
If you enable ZeroStartPIN , the system allows PIN
codes that start with the digit "0". If you disable
ZeroStartPIN , the system does not allow PIN
codes that start with the digit "0". The possible values
are as follows:
●
ZeroStartPIN=0*
ZeroStartPIN is disabled.
ZeroStartPIN=1
●
ZeroStartPIN is enabled.
CheckPINSize controls whether PINs are a
predetermined length or can be any length. If you
disable CheckPINSize, you can vary PIN digit
length. If you enable CheckPINSize, PINs must be a
set size. The possible values are as follows:
●
CheckPINSize=0
CheckPINSize is disabled.
●
CheckPINSize=1*
CheckPINSize is enabled.
You can configure PIN length on the System
Parameters section in the CRS Front End.
7000/7X0
7000/7X0
7000/7X0
7000/7X0
4 of 10
129
January 2006
Advertisement
Table of Contents
