Embedded Web Server Does Not Open - Lexmark MS312 User Manual

Troubleshooting
Action
Step 1
a
Print a font sample list to check if the fonts you are using are
supported by the printer.
1
From the control panel, navigate to:
Menus > Reports > Print Fonts
2
Select PCL Fonts or PostScript Fonts.
b
Resend the print job.
Are you using fonts that are supported by the printer?
Step 2
Check if the fonts installed on the computer are supported by the
printer.
Are the fonts installed on the computer supported by the printer?

Embedded Web Server does not open

Action
Step 1
a
Turn on the printer.
b
Open a Web browser, and then type the printer IP address.
c
Press Enter.
Does the Embedded Web Server open?
Step 2
Make sure the printer IP address is correct.
a
View the printer IP address:
•
From the TCP/IP section in the Network/Ports menu
•
By printing a network setup page or menu settings page,
and then finding the TCP/IP section
Note: An IP address appears as four sets of numbers
separated by periods, such as 123.123.123.123.
b
Open a Web browser, and then type the IP address.
Note: Depending on the network settings, you may need to
type "https://" instead of "http://" before the printer IP
address to access the Embedded Web Server.
c
Press Enter.
Does the Embedded Web Server open?
Yes No
Go to step 2. Select a font that is
supported by the
printer.
The problem is Contact
solved. support.
Yes No
The problem is Go to step 2.
solved.
The problem is Go to step 3.
solved.
191
customer