Lexmark MS312 User Manual page 108

Understanding the printer menus
Use
Timeouts
Hibernate Timeout
Disabled
20 minutes
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
Timeouts
Print Timeout
Disabled
1–255
Timeouts
Wait Timeout
Disabled
15–65535
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Error Recovery
Max Auto Reboots
1–20
To
Set the amount of time the printer waits before it enters
Hibernate mode.
Note: 3 days is the factory default setting.
Set the printer to Hibernate mode even if there is an active
Ethernet or fax connection.
Note: Hibernate is the factory default setting.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
Set the amount of time in seconds the printer waits to receive
an end‑of‑job message before canceling the rest of the print
job.
Notes:
•
90 is the factory default setting.
•
When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks for new
print jobs in the print queue.
•
Print Timeout is available only when using PCL
emulation. This has no effect on PostScript emulation
print jobs.
Set the amount of time in seconds the printer waits for more
data before canceling a print job.
Notes:
•
40 is the factory default setting.
•
Wait Timeout is available only when the printer is using
PostScript emulation. This setting has no effect on PCL
emulation print jobs.
Set the printer to restart when an error occurs.
Note: Reboot always is the factory default setting.
Determine the number of automatic reboots the printer can
perform.
Note: 2 is the factory default setting.
108