Lexmark MS312 User Manual page 68

Managing the printer
Using Hibernate mode
Hibernate is an ultra‑low‑power saving mode.
Notes:
•
Three days is the default amount of time before the printer enters Hibernate mode.
•
Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long
press of the Sleep button wakes the printer from Hibernate mode.
•
If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1
From the control panel, navigate to:
> Settings >
2
Select Press Sleep Button or Press and Hold Sleep Button, and then press
3
Press Hibernate >
Setting Hibernate Timeout
Hibernate Timeout lets you set the amount of time the printer waits after a print job is processed before it goes
into a reduced power state.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
•
View the printer IP address in the TCP/IP section in the Network/Ports menu. The IP address appears
as four sets of numbers separated by periods, such as 123.123.123.123.
•
If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Click Settings > General Settings > Timeouts.
3
From the Hibernate Timeout menu, select the number of hours, days, weeks, or months you want for the
printer to wait before it goes into a reduced power state.
4
Click Submit.
Using the control panel
1
From the control panel, navigate to:
> Settings >
>
2
Select the amount of time the printer waits after a print job is processed before it enters Hibernate mode.
3
Press .
> Settings > > General Settings >
.
> Settings > > General Settings >
.
> Timeouts > > Hibernate Timeout
68