Temperature Control Cable - Pontiac Fiero 1988 Service Manual

1B-30 AIR CONDITIONING
Install or Connect
Fan blower switch.
Blower switch retaining nut.
Blower switch knob.
Electrical connection at controller blower
switch.
Controller.
Three bolts at controller.
Trim plate assembly.
Four bolts at trim plate assembly.
Negative ( - ) battery cable.
[yj inspect
Controller for mode selection operation,
fan operation, and temperature lever
operation.
T E M P E R A T U R E C O N T R O L C A B L E
Remove or Disconnect
Four bolts at trim plate assembly.
1.
2.
3.
4.
Trim plate.
Three bolts at controller.
Controller.
5
6
7
8
9
10
2.
3.
4.
5.
6.
7.
8.
9.
10.
Temperature cable at controller.
Right speaker grill.
Four bolts at speaker.
Electrical connection at speaker.
Speaker.
Temperature control cable at heater A/C
module.
Install or Connect
Temperature control cable at heater A/C
module.
Electrical connection at speaker.
Speaker.
Four bolts at speaker.
Right speaker grill.
Temperature cable at controller.
Controller.
Three bolts at controller.
Trim plate.
Four bolts at trim plate assembly.
HEATER/VENTILATION/AC/DEFROSTER
See Section 8C for removal.
RETAINER
CLIP
RED
CABLE A S S E M B L Y
M O D U L E
CONTROL A S S E M B L Y
1.5 N-m (13 lbs. in.)
C A B L E ADJUSTMENT PROCEDURE
A F T E R INSTALLING & CONNECTING CONTROL &
T E M P E R A T U R E C A B L E , MOVE TEMPERATURE
L E V E L TO "HOT" IN ONE QUICK "CONTINUOUS"
FIRM MOTION UNTIL L E V E R STOPS.
J 1 0 2 5 3 - 1 B - P
Figure 29 Temperature Control Cable Routing