Table of Contents
Advertisement
TURBO HYDRA-MATIC 350 TRANSMISSION
7A3-23
I
I
Fig. 7A3-3 1 Removing Extension to Case Bolts
TO-CASE
OIL SEAL
2845
Fig. 7A3-32 Removing Extension Housing Oil Seal
Installation of Extension Housing Lip Seal
1. Install extension housing lip seal using Installer J
2 1426 (Fig. 7A3-36).
REMOVAL OF OIL PUMP SCREEN,
GOVERNOR, SCREENS AND CHECK
BALLS
Remove oil pan, oil filter and valve body as described
in On-Car Service.
Removal of Pressure Screen
1. Remove oil pump pressure screen from oil pump
pressure hole in case and clean (Fig. 7A3-37).
2. Remove governor screens from case and clean (Fig.
7A3-38).
Removal of Check Balls
1. Remove four check balls from case face (Fig. 7A3-25).
Fig. 7A3-33 Removing Lip Oil Seal
- -
Fig. 7A3-34 Collapsing Extension Housing Bushing
2EMOVAL OF MANUAL SHAFT, INNER
LEVER, PARKING PAWL, AND
INTERMEDIATE SERVO PISTON
Removal of Range Selector Inner Lever
1. Remove manual control valve link retainer from range
selector inner lever.
2. Remove manual shaft to case retainer with
screwdriver (Fig. 7A3-39).
3. Remove jam nut holding range selector inner lever to
manual shaft.
4. Remove manual shaft from case. Remove range
selector inner lever and parking pawl actuating rod.
5. Remove manual shaft to case lip seal, if necessary (Fig.
7A3-40).
Advertisement
Table of Contents
