Table of Contents
Advertisement
TURBO HYDRA-MATIC 350 TRANSMISSION
7A3-47
Fig. 7A3-1 1 2 Seating Low and Reverse Clutch Support
in Case
Fig. 7A3-1 14 lnstalling Output Carrier Assembly
-
-
-
Fig. 7A3-1 1 3 Installing Drive Shell
lnstalling Direct and Forward Clutch Assemblies
1. Install direct clutch drum to forward clutch housing
needle roller bearing (Fig. 7A3- 1 16).
2. Install direct clutch assembly to forward clutch
assembly. Install assemblies into case, making certain
forward clutch faced plates are positioned over input ring
gear and the tangs on direct clutch housing are installed into
slots on the sun gear drive shell (Fig. 7A3-117).
lnstalling lntermediate Clutch Overrun Brake
Band
1. Install intermediate clutch overrun brake band (Fig.
7A3-118).
lnstalling lntermediate Clutch Pressure Plate,
Clutch Plates and Cushion Spring
NOTE: Refer to specifications in rear of this section to
determine the required amount of lined and steel clutch
plates to use with specific transmission model and
engine. When replacing piston assembly, specific part
number must be used.
- -
Fig. 7A3-1 15 Installing Input Ring Gear
1. Install intermediate clutch pressure plate (Fig. 7A3-
1 19).
2. Oil and install lined and steel intermediate clutch
plates, starting with a lined plate and alternating steel and
lined (Fig. 7A3- 120).
3. Install intermediate clutch cushion spring (Fig. 7A3-
121).
lnstalling Oil Pump Assembly
1. Install original amount of .017 shims and needle thrust
bearing, lip side face down, on pump cover hub. Before
installation, apply petroleum jelly to both sides of shim and
Advertisement
Table of Contents
