Power On The Host For The First Time - Oracle Netra X5-2 Installation Manual

After the Oracle ILOM firmware initializes, the SP OK/Fault LED remains lit, the main
power OK/Fault LED slowly flashes, and the SP login prompt displays on the terminal device.
However, the host is not initialized or powered on yet.
8. Power on the server.
See "Power On the Host for the First Time" on page
Related Information
"Connect the Chassis Ground Wire" on page 76
■
"Assemble the DC Input Power Cord" on page 78
■
"Power On the Host for the First Time" on page 83
■

Power On the Host for the First Time

This procedure explains how to access and power on the host through the SER MGT port using
the Oracle ILOM CLI.
Ensure that these conditions are met:
1.
a. A terminal device is connected to the SER MGT port. See
SP" on page
b. Power is applied to the server. See
Time" on page 73
2. Press Enter on the terminal device to establish a connection between the
terminal device and the Oracle ILOM SP.
3.
At the terminal device, log in to the SP as root with the password of changeme.
ORACLESP-xxxxxxxxxx login: root
Password: changeme
. . .
->
After a brief delay, the Oracle ILOM prompt is displayed (->). At this point, there are many
commands you can perform using the Oracle ILOM interface.
Additional SP information, such as how to change the password and how to set up the SP
network parameters is available in
CLI)" in Netra Server X5-2 Administration
64.
"Change the Oracle ILOM Root Password (Oracle ILOM
Guide.
Power On the Host for the First Time
83.
"Powering On the Server the First
Powering On the Server the First Time
"Cable the
83