b.
Align the installation tool with the screws, as shown in the following graphic, and lower the
installation tool on the microprocessor. The installation tool rests flush on the socket only
when it is aligned correctly.
Figure 195. Installation tool alignment
c.
Using the following instructions for your installation tool to remove the microprocessor.
• When using the installation tool, gently twist the handle of the installation tool clockwise
until it locks in the "H" or "L" position, depending on the size of microprocessor, and then
lift the microprocessor out of the socket.
Figure 196. Installation tool handle adjustment
266
Lenovo System x3550 M5 Installation and Service Guide
Installation tool
Microprocessor
Handle
Microprocessor
Alignment
pins
Installation tool