Removing The Media Cage - Lenovo System x3550 M5 Installation And Service Manual

Step 10. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices
and the server.
Step 11. Start the Setup Utility and reset the configuration.
• Set the system date and time.
• Set the power-on password.
• Reconfigure the server.
See "Using the Setup Utility" on page 36 for details.

Removing the media cage

Use this information to remove the media cage.
To remove the media cage (also known as the front I/O cage), complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see "Removing the cover" on page 119).
Step 3. Remove the air baffle (see "Removing the air baffle" on page 122).
Step 4. Disconnect the cables that may be attached to the system board. This may include the DVD
drive, front USB connector assembly, front video connector assembly, operator information panel
assembly, or LCD operating panel assembly cables. After disconnecting the cables, slightly lift the
release latch; then, carefully push the media cage out of the chassis and set it aside.
Notes:
• Refer to the illustration that applies to your particular server model.
• Remember the cable routing before disconnecting the cables from the system board.
234
Lenovo System x3550 M5 Installation and Service Guide