Replacing A Usb Embedded Hypervisor Flash Device - Lenovo System x3550 M5 Installation And Service Manual

Step 4. Grasp the flash device and pull to remove it from the connector.
USB embedded
hypervisor
flash device
Figure 147. USB hypervisor flash device removal
If you are instructed to return the flash device, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.

Replacing a USB embedded hypervisor flash device

Use this information to replace a USB embedded hypervisor flash device.
To install a USB hypervisor flash device, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect the power cords.
Step 3. Remove the cover (see "Removing the cover" on page 119).
228
Lenovo System x3550 M5 Installation and Service Guide