Lenovo System x3550 M5 Installation And Service Manual page 143

(optional)
Figure 46. RAID adapter battery or flash power module cable connection for 2.5-inch hard disk drive server
models
Attention:
• Ensure that the battery/flash-power-module cable is routed straightly near the power-supply
cage, otherwise the cable might get overheated and the system board might get damaged.
• Make sure that the cable is not pinched and does not cover any connectors or obstruct any
components on the system board.
Step 7. Remove any cable covering or obstructing the holder before opening the holder.
Step 8. Install the battery or flash power module.
Steps for installing the RAID adapter battery or flash power module for 2.5-inch hard disk
drive server models
a. Release the retention clip in the open position.
b. Align the cable connector with the slot on the holder. Place the battery or flash power module
into the holder and make sure that the holder engages the battery or flash power module
securely.
Note: The positioning of the battery or flash power module depends on the type of the battery
or flash power module that you install.
c. Connect the other end of the cable to the battery or flash power module.
(optional)
.
Chapter 5 Removing and replacing components
129