List:type:list:initialize:fstep; List:type:list:initialize:preset - Keysight N5171B EXG Manual

Basic Function Commands
List/Sweep Subsystem ([:SOURce])

:LIST:TYPE:LIST:INITialize:FSTep

The current list sweep data will be overwritten once this command is
executed. If needed, save the current data. Refer to the
command for storing list sweep files.
[:SOURce]:LIST:TYPE:LIST:INITialize:FSTep
This command replaces the loaded list sweep data with the settings from the
current step sweep data points.
You can load only one sweep list at a time.
The maximum number of list sweep points is 3,201. When copying the step
sweep settings over to a list sweep, ensure that the number of points in the
step sweep do not exceed the maximum list sweep points.

:LIST:TYPE:LIST:INITialize:PRESet

The current list sweep data will be overwritten once this command is
executed. If needed, save the current data. Refer to the
command for storing list sweep files.
[:SOURce]:LIST:TYPE:LIST:INITialize:PRESet
This command replaces the current list sweep data with a factory–defined file
consisting of one point at a frequency, amplitude, and dwell time.
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
LIST This type of sweep has arbitrary frequencies and
amplitudes.
STEP This type of sweep has equally spaced frequencies and
amplitudes.
*RST STEP
Key Entry Sweep Type List Step
Supported All Models
Key Entry Load List From Step Sweep
Supported All Models
Key Entry Preset List
":STORe:LIST"
":STORe:LIST"
91