Sre; Stb; Trg - Keysight N5171B EXG Manual

System Commands
IEEE 488.2 Common Commands

*SRE?

*SRE?
The Service Request Enable (SRE) query returns the value of the Service
Request Enable Register.

*STB?

*STB?
The Read Status Byte (STB) query returns the value of the status byte including
the master summary status (MSS) bit.

*TRG

*TRG
The Trigger (TRG) command triggers the device if BUS is the selected trigger
source, otherwise, *TRG is ignored.
154
Entering values from 64 to 127 is equivalent to entering
values from 0 to 63.
The setting enabled by this command is not affected by
signal generator preset or *RST. However, cycling the
signal generator power will reset it to zero.
Supported All Models
Range 0 to 63 or 128 to 191
Remarks Refer to the Programming Guide for more information.
Supported All Models
Range 0 to 255
Remarks Refer to the Programming Guide for more information.
Supported All Models
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference