Data:pram:file:list - Keysight N5171B EXG Manual

System Commands
Memory Subsystem (:MEMory)
The preceding example downloads PRAM data to a file named PRAM_Data into
the signal generator's volatile memory (WFM1).
— "PRAM_Data"
— #14Yq8L
The data,
purposes only. Typically, ASCII characters representing data are
unprintable.

:DATA:PRAM:FILE:LIST

MEMory:DATA:PRAM:FILE:LIST
"<file_name>",<uint8>[,<uint8>,<...>]
This command loads list-formatted data directly into pattern RAM volatile
memory (WFM1). Pattern RAM memory describes how memory (WFM1) is
used and is not a distinct piece of memory. A PRAM file is specified as an array
of bytes.
This command should be preceded by a *WAI (Wait-to-Continue)
command to ensure that all pending operations are completed, before
loading the list.
Pattern Ram files are binary files downloaded directly into waveform memory
as an array of bytes. Each byte specifies a data bit (LSB 0), a burst bit (BIT 2),
and an Event 1 output bit (BIT 6). Refer to the Programming Guide for more
information on pattern RAM downloading.
Example
:MEM:DATA:PRAM:FILE:LIST "Pram_Data", 85,21,21,20,20,100
172
#
1
4
Yq8L
, in the above command is not valid and is used for example
Yq8L
Remarks Refer to
information on the file name syntax.
Supported N5172B with Option 653 or 655, N5182B with Option
656 or 657
"<file_name>" This variable names the destination file.
<uint8> This variable is any of the valid 8-bit, unsigned integer
values between 0 and 255.
[,<uint8>,<...>] This variable identifies the value of the second and
subsequent 8-bit unsigned integer variables.
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
PRAM_Data is the file name. PRAM files are saved to the
signal generator's volatile memory (WFM1).
Data block
This character indicates the beginning of the data block
Number of digits in the byte count
Byte count
4 bytes of data
"File Name Variables" on page 43 for