Dm:iqadjustment:delay; Dm:iqadjustment:external:cmrange; Dm:iqadjustment:external:coffset - Keysight N5171B EXG Manual

Basic Function Commands
Digital Modulation Subsystem—N5172B/82B ([:SOURce])

:DM:IQADjustment:DELay

[:SOURce]:DM:IQADjustment:DELay <value><unit>
[:SOURce]:DM:IQADjustment:DELay?
This command enables you to change the absolute phase of both I and Q with
respect to triggers and markers. A positive value delays I and Q. This value
affects both the external I/Q out signals and the baseband signal modulated
on the RF output. This adjustment does not affect external I/Q inputs.
The variable <value> is expressed in seconds.

:DM:IQADjustment:EXTernal:CMRange

[:SOURce]:DM:IQADjustment:EXTernal:CMRange COARse|FINE
[:SOURce]:DM:IQADjustment:EXTernal:CMRange?
This command sets the common mode offset range voltage (COARse or FINE)
for both the in–phase (I) and quadrature–phase (Q) signals going out of the
rear panel I and Q output connectors.
The common mode offset range is expressed in units of volts (mV–V). The
COARse range corresponds to a pre–existing adjustment range of ±2.5 V.
When the FINE range is enabled, the common mode offset is limited to ±100
mV.

:DM:IQADjustment:EXTernal:COFFset

Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
Key Entry Int Equalization Off On
Supported N5172B/82B
*RST +0.00000000E+000
Range
−400 το 400 νανοσεχονδσ (νσ)
Key Entry I/Q Delay
Remarks This command is effective only if the state of the I/Q
adjustment function is set to ON. Refer to the
:DM:IQADjustment[:STATe] command.
Supported N5172B/82B
*RST COAR
Range −2.5 to 2.5 V (Coarse), −100 to 100 mV (Fine)
Key Entry Common Mode I/Q Offset Range
Remarks This command is effective only if the state of the I/Q
adjustment function is set to on. Refer to the
:DM:IQADjustment[:STATe] command.
Supported N5172B/82B
61