Marker[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|17|18|19:Frequency; Marker[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|17|18|19[:State] - Keysight N5171B EXG Manual

Basic Function Commands
Marker Subsystem–N5173B/83B ([:SOURce])
Example
:MARK:REF 6
The preceding example sets marker 6 as the reference marker.
*RST
Range
Key Entry

:MARKer[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|17|18|19:FREQuency

[:SOURce]:MARKer[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|1
7|18|19:FREQuency <freq>|MAXimum|MINimum
[:SOURce]:MARKer[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|1
7|18|19:FREQuency? [MAXimum|MINimum]
This command sets the marker frequency. The frequency value must be
between the start and stop frequencies set for the sweep.
Example
:MARK6 ON
The preceding example turns marker 6 on.
*RST
Key Entry

:MARKer[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|17|18|19[:STATe]

[:SOURce]:MARKer[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|1
7|18|19[:STATe] ON|OFF|1|0
[:SOURce]:MARKer[0]|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|16|1
7|18|19[:STATe]?
This command turns a marker on or off. Marker 0 is the default if the marker
designator [n] is not specified.
Example
:MARK6 ON
The preceding example turns marker 6 on.
*RST
Key Entry
98
0
0 to 19
Delta Ref Set
Supported N5173B/83B
0
Marker On Off
Supported N5173B/83B
0
Marker On Off
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference