Pmeter:channel; Pmeter:communicate:lan:device; Pmeter:communicate:lan:ip - Keysight N5171B EXG Manual

Basic Function Commands
Correction Subsystem ([:SOURce]:CORRection)

:PMETer:CHANnel

[:SOURce]:CORRection:PMETer:CHANnel A|B
[:SOURce]:CORRection:PMETer:CHANnel?
This command selects the channel setting on the external power meter for user
flatness calibration.

:PMETer:COMMunicate:LAN:DEVice

[:SOURce]:CORRection:PMETer:COMMunicate:LAN:DEVice
<deviceName>
[:SOURce]:CORRection:PMETer:COMMunicate:LAN:DEVice?
This command enters a VXI–11 device name for a power meter that is being
controlled by the signal generator for user flatness calibration. If connecting
directly to the power meter, enter the name as specified on your power meter
documentation. If connecting through a LAN–GPIB gateway, enter the SICL
address of the power meter.

:PMETer:COMMunicate:LAN:IP

[:SOURce]:CORRection:PMETer:COMMunicate:LAN:IP <ipAddress>
[:SOURce]:CORRection:PMETer:COMMunicate:LAN:IP?
This command sets the internet protocol (IP) address for a power meter that is
controlled by the signal generator for user flatness calibration. If connecting to
a GPIB power meter through a LAN–GPIB gateway, this command sets the IP
address of the gateway.
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
Remarks For information on file name syntax, refer to
Variables" on page
Supported All Models
Default Channel A
Key Entry Power Meter Channel A B
Remarks The setting enabled by this command is not affected by
signal generator power–on, preset, or *RST.
Supported All Models
Key Entry PM VXI–11 Device Name
Remarks The setting enabled by this command is not affected by
signal generator power–on, preset, or *RST.
Supported All Models
Key Entry Power Meter IP Address
43.
"File Name
53