Fm[1]|2:Internal:function[1]|2:Shape:ramp; Fm[1]|2:Internal:noise[1]|2:Type; Fm[1]|2:Internal:sweep:function:frequency:start; Fm[1]|2:Internal:sweep:function:frequency:stop - Keysight N5171B EXG Manual

Analog Modulation Commands
Frequency Modulation Subsystem–Option UNT ([:SOURce])

:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP

[:SOURce]:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP
POSitive|NEGative
[:SOURce]:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP?
This command sets the ramp direction when
:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe is set to RAMP.
Key Entry

:FM[1]|2:INTernal:NOISe[1]|2:TYPe

[:SOURce]:FM[1]|2:INTernal:NOISe[1]|2:TYPe UNIForm|GAUSsian
[:SOURce]:FM[1]|2:INTernal:NOISe[1]|2:TYPe?
This command sets the noise type when
set to NOISe[1] or NOISe2.
Key Entry

:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt

[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt
<val><units>
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt?
This command sets the start frequency for the swept function generator.

:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP

Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
Remarks The waveform selection is only valid when INT is the
source selection. Refer to
270 for source type selection.
SINE is the only shape available without Option 303.
Supported All Models with Options UNT and 303
*RST POS
Pos Ramp
Supported All Models with Options UNT and 303
*RST POS
Noise Gen 1
Supported All Models with Options UNT and 303
*RST 400.0 Hz
Range 100 mHz to 6.250 MHz
Key Entry FM Start Freq
Supported All Models with Options UNT and 303
":FM[1]|2:SOURce" on page
Neg Ramp
":FM[1]|2:SOURce" on page 270
Noise Gen 2
is
265