System Commands
Route Subsystem (:ROUTe)
[:CONNectors]:TRIGger[2]:OUTPut
:ROUTe[:CONNectors]:TRIGger[2]:OUTPut
SWEep|SRUN|SETTled|PVIDeo|PSYNc|LXI|PULSe|TRIGger1|SFDone|NO
NE
:ROUTe[:CONNectors]:TRIGger[2]:OUTPut?
This command selects a signal to be routed to the rear panel TRIG 2 connector.
196
This choice routes the source settled signal to the TRIG
SETTled
1connector.
This choice routes the pulse video signal to the TRIG 1
PVIDeo
connector.
This choice routes the pulse sync signal to the TRIG 1
PSYNc
connector.
This choice routes the LXI signal to the TRIG 1
LXI
connector.
PULSe
This choice routes the pulse sync signal to the TRIG 1
connector.
This choice routes the TRIG 2 BNC signal to the TRIG 1
TRIGger2
connector.
This choice routes the swept function done signal (the
SFDone
pulse at the end of each full swept function) to the TRIG
1 connector.
This choice routes no signal to the <connector>
NONE
connector, which allows the BNC to be an input.
*RST
NONE
Key Entry
Route to Trig 1 BNC
Supported
As ind icated
This choice routes the sweep trigger out signal to the
SWEep
TRIG 2 connector.
This choice routes the source settled signal to the TRIG
SETTled
2 connector.
This choice routes the pulse video signal to the TRIG 2
PVIDeo
connector.
This choice routes the pulse sync signal to the TRIG 2
PSYNc
connector.
This choice routes the LXI signal to the TRIG2
LXI
connector.
PULSe
This choice routes the pulse sync signal to the TRIG 2
connector.
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference