Route Subsystem (:Route); [:Connectors]:Event[:Output]; Hardware:dgenerator:input:bpolarity; Hardware:dgenerator:input:cpolarity - Keysight N5171B EXG Manual

System Commands

Route Subsystem (:ROUTe)

Route Subsystem (:ROUTe)

[:CONNectors]:EVENt[:OUTPut]

:ROUTe[:CONNectors]:EVENt[:OUTPut] M1|M2|M3|M4|AUX29|NONE
:ROUTe[:CONNectors]:EVENt[:OUTPut]?
This command selects a marker (M1–M4) signal to be routed to the rear panel
EVENT 1 connector. AUX29 selects Aux I/O Pin 29. NONE indicates that the
BNC connector is, or can be, input.

HARDware:DGENerator:INPut:BPOLarity

:ROUTe:HARDware:DGENerator:INPut:BPOLarity POSitive|NEGative
:ROUTe:HARDware:DGENerator:INPut:BPOLarity?
This command configures the polarity of the TTL input signal at the BURST
GATE IN connector. POSitive refers to normal logic, while NEGative refers to
inverted logic.

HARDware:DGENerator:INPut:CPOLarity

:ROUTe:HARDware:DGENerator:INPut:CPOLarity POSitive|NEGative
:ROUTe:HARDware:DGENerator:INPut:CPOLarity?
This command configures the polarity of the TTL input signal at the DATA
CLOCK connector. POSitive refers to normal logic, while NEGative refers to
inverted logic.
188
Supported N5172B with Option 653 or 655, N5182B with Option
656 or 657
*RST M1
Key Entry Route to Event 1 BNC
Supported N5172B with Option 653 or 655, N5182B with Option
656 or 657
*RST POS
Key Entry Burst Gate In Polarity Neg Pos
Remarks This command performs the same function as
"HARDware:DGENerator:IPOLarity:BGATe" on page
189.
Supported N5172B with Option 653 or 655, N5182B with Option
656 or 657
*RST POS
Key Entry Data Clock Polarity Neg Pos
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference