Questionable:bert:condition; Questionable:bert:enable; Questionable:bert:ntransition - Keysight N5171B EXG Manual

System Commands
Status Subsystem (:STATus)
:STATus:PRESet
This command presets all transition filters, enable registers, and error/event
queue enable registers.

:QUEStionable:BERT:CONDition

:STATus:QUEStionable:BERT:CONDition?
This query returns the decimal sum of the bits in the Data Questionable BERT
Condition Register. For example, if no clock signal has been input for more
than three seconds during the bit error rate measurement (bit 0), then a value
of 1 is returned.

:QUEStionable:BERT:ENABle

:STATus:QUEStionable:BERT:ENABle <value>
:STATus:QUEStionable:BERT:ENABle?
This command determines which bits in the Data Questionable BERT Event
Register will set the Data Questionable BERT Summary bit (bit 12) in the Data
Questionable Condition Register.
The variable <value> is the sum of the decimal values of the bits you want to
enable.

:QUEStionable:BERT:NTRansition

:STATus:QUEStionable:BERT:NTRansition <value>
:STATus:QUEStionable:BERT:NTRansition?
This command determines which bits in the Data Questionable BERT Condition
Register will set the corresponding bit in the Data Questionable BERT Event
Register when that bit has a negative transition (1 to 0).
200
Remarks Refer to the Programming Guide for more information.
Supported N5172B or N5182B with Option UN7
Range 0–32767
Remarks The data in this register is continuously updated and
reflects the current conditions.
Refer to the X-Series Signal Generators Programming
Guide for more information.
Supported N5172B or N5182B with Option UN7
Range 0–32767
Remarks Refer to the X-Series Signal Generators Programming
Guide for more information.
Supported N5172B or N5182B with Option UN7
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference