System Commands
Status Subsystem (:STATus)
Status Subsystem (:STATus)
:OPERation:CONDition?
:STATus:OPERation:CONDition?
This query returns the decimal sum of the bits for the registers that are set to
one and are part of the Standard Operation Status Group. For example, if a
sweep is in progress (bit 3), the value 8 is returned.
:OPERation:ENABle
:STATus:OPERation:ENABle <value>
:STATus:OPERation:ENABle?
This command determines which bits in the Standard Operation Event Register
will set the Standard Operation Status Summary bit (bit 7) in the Status Byte
Register.
The variable <value> is the sum of the decimal values of the bits that you want
to enable.
:OPERation:NTRansition
:STATus:OPERation:NTRansition <value>
:STATus:OPERation:NTRansition?
This command determines which bits in the Standard Operation Condition
Register will set the corresponding bit in the Standard Operation Event
Register when that bit has a negative transition (1 to 0).
The variable <value> is the sum of the decimal values of the bits that you want
to enable.
198
Supported
All Models
Range
0 to 32767
Remarks
The data in this register is continuously updated and
reflects current conditions.
Refer to the Programming Guide for more information.
Supported
All Models
Range
0 to 32767
Remarks
Refer to the Programming Guide for more information.
Supported
All Models
Range
0 to 32767
Remarks
Refer to the Programming Guide for more information.
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference