Sweep:time[1]|2; Sweep:trigger - Keysight N5171B EXG Manual

Analog Modulation Commands
Low Frequency Output Subsystem ([:SOURce]:LFOutput)
Key Entry

:SWEep:TIME[1]|2

[:SOURce]:LFOutput:SWEep:TIME[1]|2 <val><unit>
[:SOURce]:LFOutput:SWEep:TIME[1]|2?
This command sets the sweep time for the swept-sine waveform.

:SWEep:TRIGger

[:SOURce]:LFOutput:SWEep:TRIGger
IMMediate|KEY|EXTernal|INTernal|BUS
[:SOURce]:LFOutput:SWEep:TRIGger?
This command sets the trigger source for the frequency modulated swept-sine
waveform.
Keysight EXG and MXG X-Series Signal Generators SCPI Command Reference
ON|1 This choice uses the same sweep time for both start freq
to stop freq and stop freq to start freq sweeps of a
triangle shape sweep. If sweep times coupled is ON,
sweep time and rate is only set by the Start -> Stop
softkeys.
OFF|0 This choice disables sweep time couplings.
*RST
OFF
LF Out Sweep Times Coupled Off On
Supported All Models with Options UNT and 303
*RST +1.00000000E−001
Range 1.0mS–65.535S
Key Entry LF Out Sweep Time
Supported All Models with Options UNT and 303
IMMediate This choice enables immediate triggering of the sweep
event.
KEY This choice enables triggering through front panel
interaction by pressing the Trigger hardkey.
EXTernal This choice enables the triggering of a sweep event by
an externally applied signal at the TRIG 1, TRIG 2, or
PULSE BNC connector.
INTernal This choice enables the triggering of a sweep event by
an internal Pulse Video or Pulse Sync signal.
BUS This choice enables GPIB triggering using the *TRG or
GET command or LAN and RS-232 triggering using the
*TRG command.
281